Thread: SPRINT TP2 + Drill Press + 1/16 Drill Bit = Soft Reset No Case Removal
View Single Post
  #58 (permalink)  
Old 12-03-2009, 01:11 PM
AZTECHKA's Avatar
AZTECHKA
Stupid-Ass Skull Cruncha
Offline
Location: San Diego by way of Los Angeles
  
Join Date: Feb 2009
Posts: 12,381
Reputation: 16825
AZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation levelAZTECHKA can't get a higher reputation level
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Re: SPRINT TP2 + Drill Press + 1/16 Drill Bit = Soft Reset No Case Removal
Quote:
Originally Posted by kabuk1 View Post
I just did this little mod this morning & I wish I'd have done it sooner. This will save me money on cases. I always use snap cases to protect my phone & it is a huge PITA to get them off whenever I have a lockup. I have to use a credit card to loosen the back, & after so many removals the little tabs break off & I have to buy a new one. So I used a Dremel & freehanded 2 holes, 1 through the battery cover & one through the snap case, And it turned out great! I was kind of afraid it'd look bad but it's barely noticeable. Thanks for the idea, OP.

What are you protecting your phone from?
Bullets? Radioactive fallout?
Sheesh... That's not a TP2 That's a Tank.
lol.
Great work with the hole drillin and the lining up of the holes.
p.
__________________
Reply With Quote