[toddnaz]

Originally Posted by Krayziepop

Just an FYI, but the GetSPC program doesn't work on the Diamond/Pro. You will need a registry editor like PHM Regedit, then follow these instructions. Good luck

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL

Excellent post, thank you. I used GetSPC on my Titan with no problem but couldn't figure out how to do it on my TPro. First thing is when I try to open up ATDbg0.txt it errors out and says sharing violation or something. So all I did was make a copy and pasted in the same directory and opened that up. Then you got to look thru all of the command lines until you find the one above with your phone's MSL#. Another thing I noticed that happens when you try to edit is that if you turn off the radio beforehand it won't let you go into EPST mode. So go into EPST (##778#) then turn off the radio then go into edit. They just make it a little more difficult but you can get in there.