Quote:
Originally Posted by kvb1085
FORGET WHAT I SAID ABOUT THE MODEL NUMBER!!!
i'm an idiot.. i coulda swore it had both model numbers on the phone itself.. it's only the BATTERY that has both model numbers.. (honestly i'm not that dumb.. sorry for the confusion)
It is a Sprint phone through and through.. i've been following these instructions here:
http://forum.ppcgeeks.com/showthread.php?t=15920&page=2
i've gotten the msl from the phone
but when it comes to running qpst i have NO IDEA what i'm doing.. so i'm stuck.. |
diagnostic mode by ##3424 or ##3424# on phone
also to get ur msl (and mslgrabber didnt work)do this
* Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1
* Wait a reasonable amount of time and soft-reset (I have noticed that it seems to take longer for this value to take affect, so if you reboot and the registry values are not changed, then you need to do it again and wait longer)
* Check to see that the file \Temp\ATDbg0.txt has been created.
* Return the values back to what they were (most likely 0) waiting the same amount of time as above.
* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:
Code:
11:9:3 Tx:AT+HTC_RMSL=0\r
11:9:3 Rx:+HTC_RMSL: 354201\r\n0\r
11:9:3 Tx:AT+HTC_ROTKSL=0\r
11:9:3 Rx:+HTC_ROTKSL: 216112\r\n0\r
The numbers next to the Rx: +HTC_RMSL line should be your MSL
to connect to qpst
1. place phone in ##diag mode let the drivers install
2.open device manger(right click my computer,select manage) whatever com port that your phone is hooked to use it for qpst.
then start QPST service programming connect to said comport!!
then select read from phone, enter msl as unlock code!! once this is done save the oringal phone file to somewhere save as a backup!!! there u are connected!!