Quote:
Originally Posted by Darkness231
always close on X= Start->Settings->System->Task Manager->Button Tab. Then select "End programs by tapping "X""
If your EVDO signal is too weak it will default to 1X.
1X is about the speed up a dial up modem and EVDO is about the speed of a low end DSL
MMS size. Send or receive?
Just change all the send and receive values to 5120000 (dec)(~5mb) in the below keys
HKLM/SOFTWARE/ArcSoft/ArcSoft MMS UA/Config/mm1/MMSCSetting/SampleMMSC
HKLM/SOFTWARE/ArcSoft/ArcSoft MMS UA/Config/mm1/MMSCSetting/SampleMMSC2
|
Quote:
Originally Posted by lostcausnjtown
1. Should not need a cab for that. They should be in Settings>System>Task Manager>Button
2. I think that it will just not connect if you say EVDO only. The only way it will switch is if you put it on automatic. Downside may be a few missed emails and data when you do not have connection.
3.Look under options in the SMS/MMS menu. This is assuming you have arcsoft. If not, then I do not know where they are.
Hope this helps.
|
you 2 must not be familiar with 6.5.1, those options do not work. if you are running 6.5.1 op you will need a program called showcase.