goal is to get all non-personal settings here
[of course there are no - in the actual deal]
epst -> modem settings
slot cycle index -- 2
preferred serving system -- automatic
preferred mode -- automatic
hdr hyprid preferred -- disable
clear all mru entry -- no
hdr mobile receive diversity -- enable
cdma mobile receive diversity -- enable
epst -> prl
update prl file --- blank
prl id --- 02003
prl capability(prl type) -- IS-683C
prl capability(prefer only) Disable
prl capability(default roaming indicator) -- 0
epst -> security
hdr an auth user id(long) --
XXXXXXXXXX@mymetropcs.com [replace X's with your 10-digit phone number]
hdr an auth password(long) -- not telling@!!
ppp user id -- blank
ppp password -- blank
epst -> data parameters
packet dial string -- #777
rev. A -- enable
epst -> phone directory [i'm usa, this may vary]
emergency #1 -- 911
emergency #2 -- *911
emergency #3 -- #911
#1 name -- 112
#1 number -- 112
epst -> M.IP settings
number of profiles -- 6
active user profile index -- 0
mip_mode -- simple ip only
mip registration retries -- 1
mip registration retry timeout -- 2000ms
mip pre-registration timeout -- 30
mobile node-ha authentication -- disable
send a registration request only in use -- enable
dormant handoff optimization -- disable
epst -> M.ip Default Profile
enable profile -- enable
NAI -
XXXXXXXXXX@mymetropcs.com [X -> 10-digit phone # again]
mn ha spi set -- enable
mn ha spi value( hex ) -- {not sure if this is personal}
mn aaa spi set -- enable
mn aaa spi value( Hex ) -- {not sure if this is personal}
reverse tunneling preferred -- enable
home address -- 0.0.0.0
primary ha address -- 0.0.0.0
secondary ha address -- 0.0.0.0
ha shared secret -- {not sure if this is personal - dont think so}
AAA shared secret - NOT TELLING!
dmu public key(pkoid) -- 0
mn authenticator( hex ) -- 0
[edit 1]
noticed btw that:
epst -> M.ip Default Profile
mn ha spi value( hex ) -- {not sure if this is personal}
mn aaa spi value( Hex ) -- {not sure if this is personal}
the two values above are the same.