View Single Post
  #245 (permalink)  
Old 10-31-2009, 08:32 AM
razorloves's Avatar
razorloves
VIP Member
Offline
Location: Florida
 
Join Date: Oct 2007
Posts: 5,465
Reputation: 10803
razorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation levelrazorloves can't get a higher reputation level
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Send a message via Yahoo to razorloves
Re: RhodiumW CDMA Worldphone HardSPL Unlocker Release

Quote:
Originally Posted by savaytse66 View Post
I am having a similar problem. I am trying to unlock on Windows 7 x64, and here are the steps I followed:
  1. Ran the .exe
  2. Screen pops up "Preparing to flash, press ok to wait. I press ok.
  3. The screen goes black (like it's supposed to), Active Sync DISCONNECTS, and a box pops up: "Welcome to the ROM update utility...". I check the box "I understand the caution..." and click next.
  4. The next box pops up "Follow the instructions..." and I check the box "I completed the steps..."
  5. A box pops up: "Verifying the information on your PDA phone...please wait..."
  6. About 30 seconds go by, and an error box pops up: Error [260]: Connection...
  7. I have to soft-reset the device at this point.
I tried a second time after installing the enablerapinew.cab (using auto mode) and got the exact same errors.

Any thoughts?

EDIT: When I soft-reset in #7 above, the computer dink-donks like when you disconnect the UBS cable, so there's still some sort of connection the PC is recognizing...
put your phone into bootloader mode, then connect it to computer and allow the drivers to install. then you should see it say USB at the bottom of the phone screen, when it's done installing drivers. then disconnect phone and soft reset it and start the unlocking steps over again
Reply With Quote
This post has been thanked 1 times.