[mayoko185]

I just installed (applied?) an invisible shield on my tp2 (ordered it right after they rlsd the vzw version). I spent a good 30 min trying to put it on and took me 4 tries before I was happy with it. In the end though I have NO air bubbles and I cant even tell its on unless I look for it. My only advice I can give on how to put it on is not to just slap it on there and then start squeegeeing, you need to pick a end of the phone (I used the bottom with the 4 bottons) and put the end of the shield down and slowly lay it down while useing the squeegee to push the air bubbles out.

edit: Also I found it helpful to keep my finger tips wet from the spray at all times so the shield would not stick to my fingers.