Quote:
Originally Posted by ahuskins
What you are describing is the issue caused by changing the SuspendResume.
This is exactly how it occurs. If you slide and it doesn't answer just take a breath, like you said, then try to slide again. Problem is, it isn't always successful.
Could someone confirm that if you set SuspendResume to #777 the data arrows do or don't ever go grey? I.e. data not active. Please post your results.
|
Right, but like I said, I found a new reg edit that hasn't been tested that I've been using to kill my data and I don't really have slide to answer issues. Here you go:
Set "SuspendResume" to 58 00 00 00 33 00 99 00 88 00 39 00 58 00 39 00 29
Default is #777 and should not contain anything about GRPS
Set "CacheTime" to 60
Here's the important note:
setting SuspendResume" to "58 00 00 00 33 00 99 00 88 00 39 00 58 00 39 00 29"
makes it so you can make calls while you have a data connection.
YOU CANNOT have both on at same time
before you COULD NOT answer any calls
while you had data present.
now it disconnects the data and
makes it so you can answer calls
Thanks to Razorloves
I'd check this pup out and see what's up.
...and I can confirm the #777 edit will not disconnect data. I was using that setting last week and my data wasn't active, but "connected".