View Single Post
  #1 (permalink)  
Old 09-12-2009, 05:20 PM
boredandtattooed's Avatar
boredandtattooed
The Dyslexic VIP
Offline
Location: MI
 
Join Date: Feb 2009
Posts: 4,219
Reputation: 6117
boredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the communityboredandtattooed is a trusted member of the community
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Send a message via AIM to boredandtattooed Send a message via MSN to boredandtattooed Send a message via Yahoo to boredandtattooed Send a message via Skype™ to boredandtattooed
Did anyone have any problems with Sashimi? I did

so sashimi's pretty simple, and certainly a time saver...

all the cabs in \auto ran just fine... but when my \auto\SCwent to run, i had issues..

it would throw up the first cab, and just hang at the screen where u select device or starage card, which normally is the automated series of screens where u literally watch it select storage card, then select install...
-issues-
1) i have to manually-though in auto mode-make the selctions when every cab shows up(again, this is just for the SC setup, other is fine)

2) after install, it hangs on the "installing screen"(seen before the device/sc install popup)

3) tried this part with and without manilla on... after #2 happens, i have to hit Start, then it jumps to the next cab instead of start menu.. but still have to make both selections after... this is annoying and honestly after a few attempts i tried to run with it and manually went through with it, and it worked for about the first 4 cabs, then the start menu would actually show up like it should, but now not loading up the next cab...

i made sure everything from 6.5 was taken out, i made sure my reg was cleaned up, in fact i didnt even import a reg for this, and thats auto processes that run After the cab installs anyways... but basically it wont run all the way through unless i remove all the cabs from the SC folder and skip em completely...

is there a script in there that controls the full SC sutomation process that some how might of got messed with??? any ideas at all??

i worked with for about 3hrs last night, after my 1st attempt... ive never hard reset so many times in one sitting LOL .. i moved stuff around, went cab by cab deleting em, the hard resetting, and running sashimi again to see if the first cab trying to load would be the issues instead... after 5 or so attempts with that, just removed everything from SC and it ran fine all the way through to the very end

makisu, all my other xmls, pim restore, everything in root, and the device cabs, ALL install fine...... if i have nothing in th SC.. otherwise i get stuck and have to abandon the process altogether
__________________
Sprints new slogan should be " Whether its a Early Upgrade or charges for nothing, We'll be there"
Reply With Quote