Quote:
Originally Posted by ucpro
sorry guys i haven't been on since i posted, and my email stinks lol.. i'm not sure what pagepool is, and even when i try a hard reset it doesn't do it. is the phone supposed to just cut off without any warning?
here's what I do:
i hold the volume down and center button, between the call and end buttons, and the only thing that happens is my volume bar just goes down and that's it.
i do have the cleanram and it'll take it down maybe 3%. i think the most i got out of it was 4mb.
i wish i didn't have the verizon but i really didn't have any choice, but that does tick me off that this same phone on another carrier would be around 50% instead of this 70-99% that i'm getting now
|
Neither memaid or hard resetting is going to help you here...
The problem is the ROM you flashed is taking up all the ram in your unit becuase your pagepool is too high....
Here is the step by step solution:
1 - Go into the RUU folder of your calkulin rom installer and look for a program called pagepoolchanger.
2 - Run it and press select
3 - Browse to the RUU folder (if not there already) and select the RUU_Signed.nbh file.
4 - It will scan the file for the current pagepool setting, when it is done select the radio button next to the 12 and press change
5 - When it is done, close the PP changer, put phone into bootloader mode (power,vol down and reset) and reflash your ROM.
6 - Let it go through all of the customizations and reset itself...
7 - when the restart is done dial *228 1, The phone will reboot when finished programming
8 - when restart is done dial *228 2, Phone will reboot again...
9 - Other than syncing with your computer and re-installing software not included in the rom your done!
You should wind up somewhere in the 60's on rom usage unless you loaded the rom up with a ton of software. If that is the case you could try reducing the pagepool to 8 instead of 12. Or rethink exactly how much software you have packed into the rom...
I tend to keep what is included in the rom to a minimum and prefer to install most of the apps into my storage card instead of device. It leaves the memory free for programs. Only programs that actually require to be installed into the device memory is included in my roms. The rest is all installed to the storage card.
If this doen't help and you find you need to remove some software included in the rom then download Calkulin's kitchen and remove the packages you do not use. Remember to set the pagepool to 12 or less before flashing.