This thread is the closest I have found to describing my problem. It is going to be long winded so here we go:
I have been watching and reading about upgrading my uscc 6800 for about 6-8 months now and yesterday I took the plunge.
I used the upgrade instructions that were spelled out here:
http://ppcgeeks.com/forum.ppcgeeks/s...ad.php?t=24511
I followed the directions, or so I thought. I ran the hard-spl-mfg.exe and everything was working just fine. After following the on screen instructions the program ran the RUU program. I had read ahead in the instructions and didnt think this needed to be ran until I was ready to copy my os rom onto the phone.
This is where I really messed up and I am hoping I didnt mess it up for good.
I ran the RUU with the cooked os rom and installed it on my phone. Now my phone only boots to the sub splash screen.
As best as I can tell this is because I didnt actually "commit" or permanently copy the unlocked bootloader onto the phone and also because the radio did not get upgraded.
From what I am reading I think all I really need is the nhb file that is created from the nueSPL-2.47 unlocker, but I am not sure. I think from there I can reflash the os rom and radio appropriately. My big problem is that since I cannot connect the phone to activesync I cannot run any of those type of unlockers and since my phone will not boot into windows mobile i cannot run the nueSPL-2.47.exe either.
If someone can provide some direction or provide the nhb file that would be greatly appreciated.
My current phone specs:
USCC 6800
ROM: winmo 6.5 (latest build available in buildos)
Radio: 1.64.00
Protocol: ACAAAAM-4070
The first splash screen shows the following
NueKernel-3.01
build 109 (c) 2008 No2Chem
Low mem (camera enabled)
M 09 P ACAAAAM-4070
B 03 R 1.64.00
D 3.56
Thank you to any and all in advance for all of your help.
-Brent