View Single Post
  #1 (permalink)  
Old 08-19-2009, 07:51 AM
u217946's Avatar
u217946
N00b
Offline
Location: USA, Bronx NY
 
Join Date: Apr 2009
Posts: 30
Reputation: 55
u217946 is becoming a great contributor
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Post Explaining Cell Phone Reception

I have stumble upon several people that constantly complaining about their reception and blaming it on the ROM sooooo. Here is an explanation on how Reception works, hope you like it.

How Cell Phones Work
Cell phones are essentially "radios." They communicate to the world by transmitting and receiving voice through cell towers setup throughout the area. And a carrier's coverage is a network of cell sites, each with a tower and base station controller for a range of about 10 square miles.
From a carrier's standpoint, great coverage comes at various technological expenses and certain restrictions that are out of their control. For instance, each provider is limited by the FCC to a number of frequencies it can use in any given city.
Given a limited number of frequencies available in the spectrum, in order to sustain the capacity needed for urban coverage, frequency reuse is required.
To put it into an extreme example, if there was only one tower covering all of New York City, only a limited amount of simultaneous users could use that tower at once due to FCC regulations, say 100 frequency slots. Thus, 100 users at once could use it.
Conversely, if each house had its own tower, 100 users would be able to talk on their cell phones simultaneously in each house. Since each tower now only has a few feet to cover, power consumption is greatly lowered. Once a guest walks to a neighbor's apartment, the current tower would hand off the user to the next tower, freeing up a spot of another person.

Where's the Reception?
Coverage gaps arise when there is minimal or no overlap between cell sites. Ideally, hexagonal cell sites in a grid would cover 100% of the city. However, cell sites are circular in range. Thus small gaps occur when cell sites are next to each other. When user load increases, more towers need to be built to sustain the volume.
Also as mentioned earlier, by using a network of cell sites, transmission power can be lowered. To maintain efficiency, cells ideally provide reception up to the edge of the next cell site. However, signal strength fades the farther a user strays from the tower. And if the user strays too far from the fringe of two adjacent sites, coverage can get dropped.

Other Reasons for Poor Reception
If coverage is great outdoors but vanishes once inside, a problem could be the transmission power. Since more users requires more towers to be placed, it requires less power to cover a smaller area. The weaker signals will not be able to penetrate buildings deeper.
Additionally, at the expense of power consumption, cell phones use low-power transmitters. Base station transmits at low power to keep within the cell range (mentioned above). So to provide long lasting phones, manufacturers end up trading off power for transmission and reception strength. Together these are all possible reasons for bad reception.

I got this information from: http://www.mobiledia.com/guides/page1.html
Reply With Quote
This post has been thanked 3 times.