Touch Flo & Cube for Mogul

**Young_breedent** · #1 (**permalink**) 05-20-2008, 05:40 PM

Sorry if this has been covered already but i seen the question a couple of places. This is a cab that installs both FTouch Flo and the cube. Once you install go into your programs folder click the FTouchFlo configuration tool, hit the general tab and check to box that says enable FTouchFlo and press done at the bottom left hand corner. Then go back to the today screen and swipe your finger up and BAM there you go the wonderful cube.....it usually take about 20-30 seconds to open the first time but it's good to go from there hope this is helpful http://www.filedropper.com/htccubeft...0config-xplode

p.s. if some one can put this in the ppc geeks kitchen that would be wonderful there is already one in there but it is only for the touch and i am referring to the cube not touchflo

Please say thanks if this was helpful

natefish · #2 (**permalink**) 05-21-2008, 03:43 PM

Thanks for posting this. When I run the cab, I get the message about not having necessary permissions and so installation is unsuccessful.

Any suggestions? I am pulling my hair out trying to get this to work.

tunerstk · #3 (**permalink**) 05-21-2008, 04:22 PM

Id love to know who this works for I though the CUBE would not run on Mogul?

**Young_breedent** · #4 (**permalink**) 05-21-2008, 04:26 PM

it works for anybody who tries it i been using this cab for like 4 or 5 months now

**Young_breedent** · #5 (**permalink**) 05-21-2008, 04:28 PM

Quote:

Originally Posted by natefish

Thanks for posting this. When I run the cab, I get the message about not having necessary permissions and so installation is unsuccessful.

Any suggestions? I am pulling my hair out trying to get this to work.

thats weird i have never gotten that message with any of my builds that i have installed this cab on.....i would recommend istalling it right after you have flashed to a fresh rom and it should work if not im sorry i can't help any further i just found the cab i didn't create the cube or touchflo....i do actually have another way of adding the cube though just pm me

**spetrillo** · #6 (**permalink**) 05-27-2008, 08:31 PM

Can someone re-post the download...looks like the link is now dead.

RicoRich196 · #7 (**permalink**) 05-27-2008, 08:41 PM

The link works fine, my question is, how easy is it to uninstall this thing? Anyone know?

tharris297 · #8 (**permalink**) 05-27-2008, 09:10 PM

i got this one from ppctech (forgive my spelling) last night on #ppcgeeks freenode chat room. It has cube and ftouchflow) works nicely and is fast. at least fast enough for me.

**flyers2114** · #9 (**permalink**) 05-27-2008, 11:28 PM

Quote:

Originally Posted by tharris297

i got this one from ppctech (forgive my spelling) last night on #ppcgeeks freenode chat room. It has cube and ftouchflow) works nicely and is fast. at least fast enough for me.

I have that cab also and ran it on my mogul......just didnt like it so I uninstalled it...seems like it is too hard to get back to main screen...maybe I did not play with it long enough....

warrior1153 · #10 (**permalink**) 05-27-2008, 11:45 PM

i install it but when it says touchflo is running i still have the same wm6 format and everything how do i install it correctly thanks