VoiceCmd.exe crashes when phone is rebooted in Vibrate?

Protonus · #1 (**permalink**) 09-18-2009, 01:00 AM

Just wondering if anyone else has seen this issue. Put your phone to Vibrate for the ring. If it makes any difference I'm NOT using the "one volume" setting - I have separate volume sliders for system/ring. Now soft reset / turn off/on the phone. After Touch Flo3d starts, a few moments later you'll get the standard "program encountered a problem" crash message for VoiceCmd.exe.

Doesn't happen as long as the ringer is on, took me a while to figure out this was the cause. I have all Voice command notification options on etc, and have it set to try to play overbluetooth if available.

KilgoreBA · #2 (**permalink**) 09-18-2009, 01:31 PM

Mine says there is not enough memory for Voice Command when I soft reset, even though I reboot with around 111 MB of memory. It doesn't always do this though, just sometimes and it doesn't matter if I am on vibrate or ringer. Hmm...

siff · #3 (**permalink**) 10-30-2009, 05:13 PM

Dirty install of 3rd prty

Protonus · #4 (**permalink**) 11-04-2009, 11:40 PM

Quote:

Originally Posted by siff

Dirty install of 3rd prty

Come again? Are you trying to say a 3rd party piece of software is the cause? I don't believe that's the case. It did this out of the box pretty much.

sho95 · #5 (**permalink**) 11-04-2009, 11:58 PM

Quote:

Originally Posted by Protonus

Just wondering if anyone else has seen this issue. Put your phone to Vibrate for the ring. If it makes any difference I'm NOT using the "one volume" setting - I have separate volume sliders for system/ring. Now soft reset / turn off/on the phone. After Touch Flo3d starts, a few moments later you'll get the standard "program encountered a problem" crash message for VoiceCmd.exe.

Doesn't happen as long as the ringer is on, took me a while to figure out this was the cause. I have all Voice command notification options on etc, and have it set to try to play overbluetooth if available.

I did it and no issues.

**fusion** · #6 (**permalink**) 01-02-2010, 01:30 PM

Quote:

Originally Posted by Protonus

Just wondering if anyone else has seen this issue. Put your phone to Vibrate for the ring. If it makes any difference I'm NOT using the "one volume" setting - I have separate volume sliders for system/ring. Now soft reset / turn off/on the phone. After Touch Flo3d starts, a few moments later you'll get the standard "program encountered a problem" crash message for VoiceCmd.exe.

Doesn't happen as long as the ringer is on, took me a while to figure out this was the cause. I have all Voice command notification options on etc, and have it set to try to play overbluetooth if available.

take media off of settings for voice command. see if that helps..

futrorthodr · #7 (**permalink**) 03-12-2010, 07:20 PM

Hey sorry to bump an old thread but didnt want to start a new one, but I am having the same problem with my voice command shutting down saying there isnt enough memory when there clearly is.

I took off media from the voice command settings and so far it is working but does anyone know what could be causing this issue?