Change ringtone/vibrate/LED flash characteristics
Change ringtone/vibrate/LED flash characteristics:
If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat': HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes) For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)': HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes) The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second. a = activate device cN = set volume to N in percentage max volume fN = flash notification LED for N seconds p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code. r = repeat. Note that this should be the last code in your Script string, if used at all. vN = vibrate for N seconds wN = wait for N seconds. Note that the device will wait this long before continuing with the next code. |
Hi. Everytime, I do one those registry edits, it works when I try it but somehow it reverts back to it's original pattern once, I change the volume or soft reset the phone. How do I permanently change this. thanks
|
Re: Change ringtone/vibrate/LED flash characteristics
just a bump and to say this does stick, after changing vol & reboot.
|
Re: Change ringtone/vibrate/LED flash characteristics
does this work with sms?
~chevy |
All times are GMT -4. The time now is 03:09 PM. |
Powered by vBulletin® ©2000 - 2024, Jelsoft Enterprises Ltd.
©2012 - PPCGeeks.com