Quicker Ring Response
 

This was originalyy posted by "ELKAY" over on the pdaphonehome.com forums...

"To do this, you will need your MSL, which only Sprint (or your provider) can provide you.
Open up the phone app and dial ##778# (PST). You will be asked to enter your MSL. Enter it, and you will be brought into the provisioning of your phone. From the top left, select Modem Settings. On this page, your Slot Cycle Index (SCI) is how often your phone polls the tower for incoming calls, etc.
This value is 1.28 seconds multiplied by 2^value (i.e 0=1.28 secs, 1=2.56secs) with 0 fastest, 7 slowest. The default is 2, but lowering it to 1 hasn't noticeably affected my battery life, and roughly 2.5 second (SCI 1) response time is far more reasonable than roughly 5 seconds (SCI 2)."

i used a setting of "1" after getting my msl from tech-support....
Did a soft boot to be safe then checked it and made sure the setting stayed...

i noticed a very good improvement in response time and ill post back tomorrow on battery difference if there is one at all....


VERIZON directions

1. Open up the phone app
2. dial ##778
3. hit send
4. a screen will pop up asking for a code
5. enter 000000 ( thats 6 zeros)
6. click ok
7.You will be brought into the provisioning of your phone
8.From the top left, select Modem Settings.
9.On this page, your Slot Cycle Index (SCI) Your phone should have a 1 in that spot
10. Click edit change it to 0
11. click the ok button then the X in the upper right hand corrner
12. The VX6700 will restart and its all done...


) is how often your phone polls the tower for incoming calls, etc.

Does this mean that by setting it to "0" that the tower is continuously polled? Is this setting going to raise any eyebrowse? I don't want to upset anyone.

Hmm....not working for me
 

I'm using a 700wx and when I type it in, the phone just deletes it and does nothing. Anyone have any problems like this? Know how to fix it?

or u can use tweaks 2k2 ... there is a built in hack for it.....