I think that's a wrap for my Titan.
 

I had just finished installing the 3.35 ROM and I began downloading the Olipro SPL 2.40 and now my phones stuck in the bootloading screen. I have no way to get it out. Any advice would be appreciated.

Re: I think that's a wrap for my Titan.
 

Remove the battery for 30 seconds, put the battery back in and power on. Then try installing the SPL again. You'll only brick it once you downgrade back to a pre-GPS ROM. And welcome to the site fellow Newarker.

Cheers,
Prime

Re: I think that's a wrap for my Titan.
 

Much thanks....Trying it now....How on Earth did you know where I was from????

Re: I think that's a wrap for my Titan.
 

That didn't work....My brick screen reads "OLIPRO SPL2.40" If that means anything.

Re: I think that's a wrap for my Titan.
 

It worked for me when I had the same installation problems, but I would also try a soft reset, and if that doesn't work, hold both of the soft keys and the reset button and hard reset it manually.

NOTE - also be sure to use a backup for PIM (dotfred's most recommended) from your storage card and restore to the same device you backed up.

Re: I think that's a wrap for my Titan.
 

Disregard....I was able to reflash the 3.35. All is good.

Re: I think that's a wrap for my Titan.
 

It's likely not bricked. Most likely you just gotta flash a new rom.

Did you try reflashing a new rom yet? If your computer doesn't find it when you run the upgrade, you can still flash from sd card. Do you know how to do that? There's plenty of threads on this forum that will tell you how.

Re: I think that's a wrap for my Titan.
 

Glad it worked for ya, but you ca also flash 3.56 as it has 6.1

Re: I think that's a wrap for my Titan.
 

Nice: I work in EWR too.

Re: I think that's a wrap for my Titan.
 

Dude, I work for Essex County division of Welfare downtown. :)