Originally Posted by matt19 (Post 352444)

when i get home i will prove to all you damn haters out there that it does work and all...... all you have to do is use take off the old ram chip from the board and than take the new ram chip that i purchased and solder it at an angle and move some of the connection ports so it fits correctly and than you got it.

Originally Posted by matt19 (Post 352444)

when i get home i will prove to all you damn haters out there that it does work and all...... all you have to do is use take off the old ram chip from the board and than take the new ram chip that i purchased and solder it at an angle and move some of the connection ports so it fits correctly and than you got it.

Originally Posted by flyers2114 (Post 352758)

Not hating on you bro.....just need to see it to believe it....everyone I talked to said it could not be done....if you achieved it props to you.....=D>

Originally Posted by tharris297 (Post 345916)

I don't know a whole lot about versions and aku's etc, but I have been trying out this latest dcd 3.2.2 and it doesn't seem to have the bottom bar problem. I am using dcINoBar and it works just fine. He is using 19960 1.2.2 from what I can tell. Check out my screen shots.

Originally Posted by Giovanny (Post 352889)

Does the beam on this ROM work?

Originally Posted by nick aguas (Post 353138)

well i haven't heard of anyone having a problem with it, so i would assume so. i personally dont use beam.

Originally Posted by matt19 (Post 352838)

yup look at the guy above your post he has seen the pictures too so theres another....