Titan Rebooting And Rebooting
 

HELP HELP, CAN SOMEONE HELP! :angry7:

I have followed all instructions on upgrading the ROM and RADIO, but my phone continues to REBOOT AND REBOOT. Can someon :???: help, PLEASEEEEEEEEEEEE HELP WITH INSTRUCTIONS on how to stop the REBOOTING!

](*,)

Re: Titan Rebooting And Rebooting
 

What is you Radio,Rom and SPL versions. I suspect you are using the incorrect version SPL for you ROM

Re: Titan Rebooting And Rebooting
 

ROM 3.16, Radio 3.27, Not SURE SPL 1.40 OLIPRO???? Not Sure, Thanks for response.

Re: Titan Rebooting And Rebooting
 

Thats your problem, you need spl 2.40 for any radio of 3.27 or higher. Load in that Unlocker, hard reset and things should come right.

Trick to load this SPL in is to
Hard reset your phone
Boot to the Wellcome screen BUT do not tap your screen
At this stage plug in your phone into your PC and apply the SPL unlocker.

I'm on line for another 30 minutes if you need help.

Re: Titan Rebooting And Rebooting
 

here is the unlocker

You might need Mutty so I have added that (incase you get stuck in the bootloader)


to get out of the bootloader
run up mutty
select connection of USB
type command, followed by the enter key
SET 16 0

Remember before using mutty to disconnect the USB connection in the ActiveSync options so it has full control of the USB

Re: Titan Rebooting And Rebooting
 

Im going to try now. But my phone is rebooting and rebooting, How do I follow your instructions if it will continue to reboot:evil4:

Re: Titan Rebooting And Rebooting
 

If you hard reset your phone, normally they are stable up to the point of the wellcome screen, is that not the case with yours.

Re: Titan Rebooting And Rebooting
 

Hard reset by holding down both soft keys while resetting.

Re: Titan Rebooting And Rebooting
 

yep by pressing the 2 dot keys (above the send and end buttons) and pressing the reset key at the same time.

Re: Titan Rebooting And Rebooting
 

Mutty Not working? I put in USB but then what? I don't know the other settings and when I click OK it doesn't work. :evil4:

Re: Titan Rebooting And Rebooting
 

Unplug USB cord
go into Activesync on PC and select Connetion Options
make sure Allow USB Connections is unchecked
Plug cord back in
Phone should show the word USB
Run mutty again and select USB

Re: Titan Rebooting And Rebooting
 

Got It Working, You R The BEST BEST WOW, :drunken: ](*,)

NOW Which ROM DO YOU RECOMMEND!

Re: Titan Rebooting And Rebooting
 

Great to hear

Personally I have found VetVito's Aero Rom the best for me but there are heeps out there. Just remember to check your MSID MSD and PRL if your phone can't make calls etc after the upgrade.

Lots of posts out there for that

Re: Titan Rebooting And Rebooting
 

:headbang: Thank you. I will make sure that the phone is working.

Re: Titan Rebooting And Rebooting
 

im havin trouble with this...ive flashed to newvisions hybrid and 3.27 radio...and my phone resets after a while...am i supposed to flash back to an older rom? then load the 2.40 unlocker?

after i run the unlocker its in bootloader mode...but then asks to establish an activesync connection...how am i to do that?

Re: Titan Rebooting And Rebooting
 

If it's rebooting, you probably didn't load the 2.4 unlocker. What version shows when you are in the bootloader screen?

Either follow the directions above, or load an older ROM like 2.17 then load the 2.4 bootloader.

Re: Titan Rebooting And Rebooting
 

im in bootloader now and it says 2.40

Re: Titan Rebooting And Rebooting
 

Now go reload one of the latest ROMs and the 3.27 radio.

Re: Titan Rebooting And Rebooting
 

when i unplug it, it goes back to SPL 1.20

and when i dont unplug it and SPL 2.40 is loaded...then next step is to load a ROM...but i cant because a connection is needed yet im still in bootloader mode

Re: Titan Rebooting And Rebooting
 

No connection to ActiveSync is needed to load a ROM.

However, it seems like your bootloader is jacked if it shows both 1.2 and 2.4.

Try a hard reset and see if you can get to the welcome screen. If you can, don't proceed any further. From there you should be able to get an AS connection and reload the 2.4 bootloader.

If that does't work, look back through the steps johnw suggested and try them.

Re: Titan Rebooting And Rebooting
 

step 2 of RUU states establish an activesync connection with your PDA phone, but im not able to do so because im in bootloader

after i load 2.4, thats what comes up on my screen

but if i hard reset or soft reset then 1.2 is shown

uuughhh this is frusturating

Re: Titan Rebooting And Rebooting
 

Ignore that statement in step 2, it is incorrect.

Re: Titan Rebooting And Rebooting
 

ahh i needed titan_exitbl.exe to finalize it i guess...i'll give it some time and see if i have any problems