USB storage will not mount after Clockwork one click 2.5.5
 

Something happened to my Epic where it would not boot so I had to use Odin and flashed the DK28 stock image. It boots up fine at that point...

Then I ran the one click root/recovery that installs Clockwork recovery 2.5.1.0. It completes successfully, but at this point I cannot mount the SD Card via USB to load a custom ROM for flashing. I cannot mount USB in either Clockwork recovery nor when booted up and setting the USB mode to mass storage. Nothing happens in either case and on my computer it says "insert disk".

Has anyone encountered this and found a solution? Could it be a problem with my microSD card even though I can partition and format it without any errors?

Thanks

Re: USB storage will not mount after Clockwork one click 2.5.5
 

Make sure you have USB debugging turned off in your settings, that can cause all of these errors. I hope that helps.

Re: USB storage will not mount after Clockwork one click 2.5.5
 

OK, well I have gotten it back up and running and have even flashed CW3 w/EXT4 and Midnight ROM 2.8.

I tried a few different times to get it all working properly by using Odin, wiping, partitioning, and flashing. Here are the steps I took last that now have everything working:

1) odin to DK28 - Samsung Galaxy S/SPH-D700 - XDA-Developers and http://forum.ppcgeeks.com/sprint-epi...l-tar-md5.html

2) one click root w/CW3 - [MOD] Ported Clockwork Mod version 3.0.0.5 [READ OP CAREFULLY!][RELEASED!] - xda-developers

3) flash Midnight 2.8 - http://forum.ppcgeeks.com/sprint-epi...13-2011-a.html

Re: USB storage will not mount after Clockwork one click 2.5.5
 

any reason you didnt flash midnight 2.9? glad you got issue resoled though.

Re: USB storage will not mount after Clockwork one click 2.5.5
 

well I did this the other day before 2.9 was posted here, but I am actually about to flash 2.9 right now.

Re: USB storage will not mount after Clockwork one click 2.5.5
 

gotcha, just making sure you saw the update.