Problem with S2U2
 

I am having an issue with S2U2 where, for no apparent reason, the slide graphic ceases to animate. I can still do the unlock gesture to unlock the phone.

The problem goes away with a reset.

Anyone else experiencing this?

Re: Problem with S2U2
 

what version are you using? could be your settings. are you set to directdraw? should be set to raw buffer.

Re: Problem with S2U2
 

I believe it's version 1.33? I had it set to directdraw before, now it's GDI. Is that the same as raw buffer?

Re: Problem with S2U2
 

no, rawbuffer is another choice.

Re: Problem with S2U2
 

Interesting. I only have GDI or directdraw as choices...

Re: Problem with S2U2
 

then uninstall and reinstall. there should be at least 3 choices. it will not run correctly with anything except for rawbuffer. and my experience with GDI setting ruins it completely and even "settings" doesn't work

Re: Problem with S2U2
 

Also be sure you have the VGA version. If not that could also be causing problems.

Re: Problem with S2U2
 

I had the same problem after I ran SPB Backup. I created a backup, and then afterwards, the slide stopped appearing on the lock screen.

Here's what I did: Went in, toggled any setting on and then off, saved the changes. That seemed to reset S2U2 and I haven't had a problem since. I also have not run SPB to create a backup since this happened, so I am not sure.

OP, are you running SPB Backup as well?

Re: Problem with S2U2
 

no it is defiantly rawbuffer

Re: Problem with S2U2
 

In case you were referring to my findings, I have been set to RawBuffer since I installed S2U2 on my TP last weekend. Only incident I have had was after running SPB to backup my device.