Re: Sprint ## code for touch pro 2
 

What does ##37872# - Full Speed USB Mode - Enable/Disable do

Re: Sprint ## code for touch pro 2
 

I would like to know this also

Re: Sprint ## code for touch pro 2
 

http://www.ppcgeeks.com/forums/showthread.php?t=87414

find it here without all the hassle.

not sure if it will work on verizon.

Re: Sprint ## code for touch pro 2
 

Full Speed USB is the slow compatible mode method.
You want to leave it at default Hi-Speed.

from everythingusb dot com:

"USB 1.1 allowed a maximum transfer rate of 12Mbits/second. It is now obsolete, but both of its speeds (1.5Mbps & 12Mbps) are being adopted into USB 2.0, and they are now called Original USB officially. Though some manufacturers label their products Full-Speed USB. Note that this seems a bit deceptive as it's easy to mistake Full-Speed for Hi-Speed. You won't be fooled from now on as you now aware that Full Speed USB is only 12Mbits/second where Hi-Speed USB mode is capable of a much faster 480Mbits/second."

Found this here....http://forum.ppcgeeks.com/showpost.p...7&postcount=22

Re: Sprint ## code for touch pro 2
 

ANyone on Mikes new ROm and having problem with getting ##3282# to work? I don't get any response in his thread....any ideas here?

Re: Sprint ## code for touch pro 2
 

Yeah, same problem. It shows EPST for a second and then disappears. The ##778# works though.. Strange..

Re: Sprint ## code for touch pro 2
 

This is strange. The Sprint stock ROM, when i enter ##3282#, it works fine. But with both Juicy R2 and MightyROM, the code splashes the EPST.exe and then it disappears and of course doesn't load...

Re: Sprint ## code for touch pro 2
 

I'm having the same issue on Energy 28008 ROM. Some codes work, some don't.

Calkulin's Kitchen 28005 ROM did work. But it could not get Tower locks with GoogleMaps.

And I could swear Energy's 28008 ROM worked yesterday and I did something to break it (Like ran Provision or something).

The #777 Popups I think are related too.

Something is not right on the Reprovisioning of these ROMs.

Re: Sprint ## code for touch pro 2
 

##778#
password: 000000

BTW: Changing the slot cycle to 1 and 0 did nothing for me. No change whatsoever.

Re: Sprint ## code for touch pro 2
 

These codes should perhaps be put in the "essentials" sticky of this TP2 forum.