Re: random problem with unable to pick up incoming call
 

?????????

my cab has nothing to do with the disconnect timmer. and there are many versions of cabs out there for the 60sec timeout.

all I am saying is that the timeout setting by its self would not cause any issues. (as long as the always on flag isn't set.)

Re: random problem with unable to pick up incoming call
 

It's the same reg edit as the 1 in here:

http://forum.ppcgeeks.com/showthread.php?t=69185

Code:
HKLM\Comm\ConnMgr\Planner\Settings\
Set "CacheTime" to 60
Set "SuspendResume" to 58 00 00 00 33 00 99 00 88 00 39 00 58 00 39 00 29
Default is #777 and should not contain anything about GRPS
setting SuspendResume" to "58 00 00 00 33 00 99 00 88 00 39 00 58 00 39 00 29"
makes it so you can make calls while you have a data connection.
YOU CANNOT have both on at same time
before you COULD NOT answer any calls
while you had data present.
now it disconnects the data and
makes it so you can answer calls
Thanks to Razorloves

Re: random problem with unable to pick up incoming call
 

asside from that code being being giberish, it's not needed for the 60 sec timeout.
my cab will fix that incorrect entry and incomming calls will be answerable again.

Re: random problem with unable to pick up incoming call
 

Thanks for the info--I will give you more days and keep you update. So far, today and yesterday I have not experiencing the issue not able to pick up incoming call-may be just my luck--only time will tell.

Re: random problem with unable to pick up incoming call
 

Sounds great! But what about the 60 sec data disconnect?
Will it work now?

Re: random problem with unable to pick up incoming call
 

yes, if all the other data settings are correct.

Re: random problem with unable to pick up incoming call
 

Apparently you thought my previous version of the Data Disconnect was gibberish, LOL!

Can you point to one that isn't?

So while my data is disconnected atm, the data counter is running on 5 hrs now (unlike prior to this conversation+change) which leads me to believe it maybe dormant but not fully disconnected...

Re: random problem with unable to pick up incoming call
 

by giberish i meant that the hex code was i deciferable in any conersion i tried. im not sure about the right one, but know the suspendresume setting is picky. i made my cab specifically because other cabs out there didnt seem to always work. something about multistring regs...

u know the suspend resume is whack when its next to imosible to answer calls while a data session is open (arrows over signal bars of any kind).

maybe u want to run the other cab, then mine.