Bricked????

[rdominelli]

Boy what a dubious honor.

OK the initial way I entered the BL was to use the Enter BL program which i had copied to my flash card.
I plugged it into the usb (the BL screen changed from Serial to USB) then I ran the Sprint Rom installer for wm6.
The installer progressed to about 99 percent.
Then displayed an error stating I would need to attempt the install again.
When I looked at the pda screen it said update complete.
I pressed the soft reset button
The screen went blank and thats where I am.

I have tried the mtty and exit bootloader program thinking that perhaps its still in BL even though the screen is blank. No Luck both report that it cannot open the usb.

I have tried the sprint update APA_SPCS_20600_303_12700_WWE_Ship.exe which runs for a bit then gives me the message This update is not designed for your device (Error 150)

I have tried the Helmi Helmi_APAC_Official_AKU3_5_Kitchen_1_0_4.rar file no luck same issue.

I have tried the no id patch on several roms with similar results. Either 150 (not designed for your device) or 101 no connection.

My computer gives usb device not recognized (I am running xp sp2). I have tries 2 cables and 2 laptops. No luck.
The charge light no longer comes on unless the battery is removed (blinks red) or the battery has been out for a while, solid red then stops).

Hard reset (two dash buttons and a reset) does not work.
BL command (power + record + reset) does not work.

Banging my head against the table, does a great vibrate mode simulation though.

Rich