Help please.
 

I tried to flash my xv6700 and now my phone is stuck on a white screen with a verizon logo in the middle. On the bottom of the screen it says...

H/W=2 P SNAZ-40306
M=12 R 1.43.00
U=4 D 3.14.30 WWE

I can still get into bootloader mode, but I can't try and flash the rom again because activesync is not recognizing the device. Can anyone please help? Even if I can just get it back to wm5. I just want the phone working again. Thanks in advance.

Re: Help please.
 

check out the thread from this link: http://forum.ppcgeeks.com/showthread.php?t=27071&page=6
follow the directions and download the .exe, install it, restart the ppcgeeks kitchen, build your rom, and when it says to attach via activesync, put your apache back into bootloader and attach. It should say serial when in bootloader and will switch over to USB when attached (hard to see on the screen). You, and your phone, will be fine; been there done that!

Re: Help please.
 

Thanks, but is there a way to do this with a pre-built rom? I just want to get it running again before I start trying to build my own rom.

Re: Help please.
 

there apparently was a problem with Lennysh's kitchen that you used and it's been fixed; you shouldn't have any problem building your own and flashing once you install the .exe from 6/4. Another alternative is to build from the Helmi kitchen that you probably downloaded when you installed the ppcgeeks kitchen. Go to file and open while in the BuildOS program and see if you have anything called Helmi 6.1 selection (or close to that) and open that, then build from there and flash. You can also wait a couple hours and use the updater to download Lennysh's v.3 kitchen; I saw a post that they're working on it. Otherwise, you can search the site for pre-built apache roms.

Re: Help please.
 

I tried this and I get the message Error 201: Get Device Data Error.

I am assuming it is because autosync isn't recognizing it. Any idea's?

Re: Help please.
 

Ok. I successfully flashed it. But now instead of a frozen verizon logo it is a frozen logo of the chef off the muppets and PPCGeeks and PPCKitchen present... Any help would be greatly appreciated.

Re: Help please.
 

Got it flashed and fully working. Thanks.