Bootloader 2.05 flash back to 2.02 mistake
 

Well I oops this one up...
I finished the Bootloaderfix step and was coping the files nk.nbf, radio_.nbf and ms_.nbf files. What I did not realize was that i places the Bell Mobility files in the folder instead of the Verizon files. When I hard booted the phone.. Bell boot splash on the phone...OMG!
I went and placed the Verizon files in the No_ID RUU files folder and tried to flash that back to Verizon... No luck...
Is there a way to return the phone back to Verizon.. I tried the Getting Your Radio back posted by Ragin Idiot.. running the mtty and then running APAC_VZW_20720_200_11000_Ship.exe but it comes back with a connection error.
Any Ideas?

TucanoRC

Re: Bootloader 2.05 flash back to 2.02 mistake
 

is there a way to flash back to Factory? I have looked all across the forum and found nothing...

Re: Bootloader 2.05 flash back to 2.02 mistake
 

is it possible that the BM rom that was applied is locked?

Re: Bootloader 2.05 flash back to 2.02 mistake
 

Well now i can not get it out bootloader mode... I have tried to use the other file to get it out of bootloader mode waiting 30 secs and then running the UNI_ExitBootloader.exe. it says:
All Data sent.. Device should now reboot.. please check screen... But the letters are faded and if i press the 2 soft keys... it will ask to restore to factory default press y...

any suggestions?

Re: Bootloader 2.05 flash back to 2.02 mistake
 

YEA!!!!! i got it out of bootloader ! I flashed the Kirvin_AKU_3.5_NoJunk and then did the hard reset and I am back to ... uh the orginal problem of try to flash it back to APAC_VZW_20720_200_11000_Ship...

Re: Bootloader 2.05 flash back to 2.02 mistake
 

The only ROM I can get to load is the MaUpgradeUt_noID.exe from the Kirvin AKU 3.5 NoJunk. The phone will boot up, but will not take any other ROM updates... Any Ideas?

Re: Bootloader 2.05 flash back to 2.02 mistake
 

All is better now.....
I have the new WM6 rom flashed to the phone.. after all that.. here is what finally fixed it...
1. mtty to PPC
2. run the UNI_ExitBootloader.exe
3. place back into bootloader mode
4. Extract Verizon APAC_VZW_20720_200_11000_Ship.exe to a folder
5. pull the nbf files in the extracted output folder
6. place files into the Kirvin_AKU_3.5_NoJunk folder....
7. run the MaUpgradeUt_noID.exe from the Kirvin AKU 3.5 NoJunk
8. BAM! ran the Build-0S and BAM BAM ;~) We are rocking at WM6...
TY TY!

Re: Bootloader 2.05 flash back to 2.02 mistake
 

When I try to unrar bootloaderfix.rar, it asks me for a password. What is the password? kind of stuck without it