Sprint PPC 6700 will not boot / post after 2.0 or 2.2 rom
 

I ran the upgrade on my phone and followed the instructions and everything said that it ran perfectly and upgraded everything but it didn't do anything after my upgrade even after doing a hard and soft reset and holding down the power and memo record buttons it just shows a dimly lit word serial and at the bottom of the screen v2.02. I removed the battery and let it even sit for 10 min and still nothing. What can I do to fix this or even go back to the original ROM??

Help
Scooby

Hold down both soft keys and use ur stylus to push the reset key. If done right another screen will come up asking you to clear storage. press y for yes and then press space bar to reset. It should the reboot.

yea its in bootloader when it says serial, rerun the upgrade in bootloader mode, then hard reset. ;)

Im having the same problem... i've tried running the upgrade with that screen on and it shows the progress on my laptop and on the phone screen... shows 100% upgrade complete, then I reset it and it goes right back to the screen with serial v. 2.02 at the bottom...

i remember when this happened, I was so furious.
some info on the problem here
http://www.ppcgeeks.com/new-rom-avai...ate-t1390.html