yeah, HardSPL for CDMA Diamond is ready, just need to package it up into a userfriendly package. will do that in the evening.
edit: scroll down, it is done :D
though, I must mention, rebasing the SSPL was a real hard task, the GSM diamond was easier in some ways (and in others, not - anyway, you can get GSM version at xda-devs)...
there will be two HSPL's.
1. 0.43.MFG for the hackers, because otherwise, it is too old, apparently has screen issues in WM, which is easily fixed by a power off / on (suspend / resume) cycle. but it has mw, it has rtask, has lnbh, etc. etc. :D
2. 0.57 for other people, this has no screen issues.
(the SSPL is based on 0.43.)
thanks to tobeychris for testing. :D and it was fun to work with no2chem!
so stay tuned... & here are some photos until then...
***************************
UPDATE: HardSPL is released... now!
thanks to tobeychris and ghettofreeryder for testing!
Instructions:
0) make sure you have .NET framework installed on your PC! if not, get it from
http://www.microsoft.com/downloads/d...DisplayLang=en
1) download Hard-SPL package from attachment, extract to an empty folder.
2) it is recommended you download only the DiamondC_HSPL057.zip unless you want to tinker with MFG SPL.
3) you must Have Phone Synced with PC in Windows Mobile!
4) run DiamondC_HSPL057.exe (or maybe 043, if you want to experiment with MFG SPL),
5) follow steps in the RUU, and check on the device for prompts after PC shows loading bar.
6) it should go to tricolour screen now and say SSPL0.43.CMONEX.
7) SPL flashes, device automatically reboots, job done.
8 ) to confirm you got it installed, go into bootloader mode (tricolour screen!) and verify the screen shows 0.57.CMONEX (or 0.43.CMONEX MFG).
NOTE: you will not see the SPL version during normal boot, that is the OS version, not SPL!
to enter bootloader mode to see version: with the device turned on, press and hold the volume down button along with the power button, then press the reset button with the stylus tip, then release the volume down and power buttons when bootloader tricolour screen appears.
NOTE 2: anyone having problems with the device entering SSPL automatically, please copy SSPLManual.exe from the SSPLManual.zip attachment to the device and run it. then once the screen is in SSPL, run RUU manually. i.e. you run the RUU on the PC, if it isn't obvious.
NOTE 3: this is unsigned Hard-SPL. no limitations on flashing ROMs or radio packages. also, this has overwrite protection, if someone needs to revert to stock SPL for warranty reasons, a stock SPL downgrade package will soon be posted.
NOTE 4: do not use this RUU to flash anything else! this is only intended for flashing the HardSPL.
finally, if you somehow wish to thank me with a donation, you can:
click here :)
enjoy!
