How to enter the boot loader
I'm assuming this is the same for the CDMA versions. Anyone confirm?
Quote:
|
Re: How to enter the boot loader
just did it yesterday, its the exact same. The alltel verison is different though with version numbers. this is what I got:
PANT200 SPL-0.38.0000 CPLD-2 so we have an older spl but a newer hardware build |
Re: How to enter the boot loader
just tried it on mine, i got:
PANT200 SPL-0.36.0000 CPLD-2 Mine is a pre-release though, got mine in early january before they were launched and recalled |
Re: How to enter the boot loader
could be the difference between the alltel version and the sprint version too
|
Re: How to enter the boot loader
Before I finally purchase one, can I access the NVM folder with MSL easily from bootloader?
|
Re: How to enter the boot loader
My Pro is a Pant200 ,SPL- 0.37.0000 ,CPLD-2 haven't checked the few others but I'll get to them in a little while. I know this a later date so I hope this is worthwhile for you.
|
Re: How to enter the boot loader
My Pro was given to me by Sprint for having too many issues with the 800w, I saw that there was an update with ROM 1.03 to the 1.04, when performing the update, I may have by accident moved the USB cord, now the phone wont boot up nor a hard reset will do, the boot loader screen will come up with the following in RUUNBH PANT200 SPL-0.36.0000 CPLD-2 upgrade ROM code error Please try again
Anyone have an idea on how I can get the update or restore to default the device? |
Re: How to enter the boot loader
Hardcore,
Start the 1.03 to 1.04 update, when the tools extract themselves there will be an ruu_signed.nbh, put that on a FAT32 formatted SD card called pantimg.nbh. Force bootloader mode and it should re-flash for you. |
Re: How to enter the boot loader
khalaan,
Thanks, I was up all night trying different ways to get the device to pick up on my pc, I found a way which was removing the battery hitting end,camera,and reset. while holding the buttons went and inserted the battery back on the released the buttons the computer picked it up, but i was lucky one of the attemps to reach 77%, so I tried what you said, Formatted an Micro SD card into a FAT32 format card, Extracted the 1.03 t0 1.04 upgrade file rru_signed.nbh, renamed that same file to pantimg.nbh, put that remaned file into the micro sd card, insert the card to the device put it on the bootloader page, and ran the install, thank you again for the adive, it was very helpful. |
Re: How to enter the boot loader
i got:
PANT200 SPL-0.37.0000 CPLD-2 hope this helps been itchin for an unlocker...hahaha |
All times are GMT -4. The time now is 10:26 PM. |
Powered by vBulletin® ©2000 - 2024, Jelsoft Enterprises Ltd.
©2012 - PPCGeeks.com