|
||||
Re: Flashing question
Try doing a hard reset with the stock Rom first then flashing it.
Just a guess but would be worth the time to see if it helps. |
|
||||
Re: Flashing question
I dont think the Hard-SPL unlocker is included.
Check out this post about half way down, theres some specific instructions for VZW users. http://forum.ppcgeeks.com/showpost.p...59&postcount=1 |
|
||||
Re: Flashing question
Should have put that in my list of "tried's" as well. I went to that post first, dowloaded the unlocker and wnet through the steps, when i put the phone in bootloader it goes to the "loading" screen and stays there for eternity. After runnning the RUU, and the bootlader screen comes up it does say "security unlocked"
I cant believe this is such a pain. On my 3 previous TP's, I ran the RUU and done. It was a 5 minute affair. Didnt even get through an entire beer each time. Last edited by Rabid1; 08-20-2009 at 07:04 PM. |
|
||||
Re: Flashing question
Progress. Finally. Using the unlocker here http://forum.ppcgeeks.com/showthread.php?t=69854
Its finally working. Until next week when the screen/keyboard craps out. Thanks to all of you for your suggestions. |
|
||||
Re: Flashing question
FYI, when your in bootloader it always says "security unlocked" if its unlocked it should say spl-0.35. cmonex. if its locked it will be somthing like .35.0000 or something like that. it saying "cmonex" is the important part.
Last edited by Mylt1; 08-20-2009 at 08:19 PM. |
|
|
|