Sashimi
 

man i am so confused with this app. i am not able to get the automatic install to occur. i have followed the tutotial found on the download site to a tee. can someone confirm that with custom roms, such as D.C.D.'s newest roms, this app can be used to install my cabs automatically after a fresh flash. does this occur during the customization phase of the flash or after the flash is done, when i manually do something. in other words, i expected the process of installing my 20 cabs to be automated, during flash process.

below is the config i used without a successful results.

AUTORUN and UC INITIATED OPTIONS

Although starting SASHIMI in Auto Install mode takes only a few quick seconds, there have been questions on how to further automated SASHIMI following a clean install.

Due to these requests to automate SASHIMI to run without additional manual intervention, the following methods were developed:

AUTORUN - AUTORUN allows SASHIMI to run automatically when a Storage Card containing SASHIMI is placed into a device. This option is best suited for a brand new device or when provisioning many devices (such as in a corporate usage). To use Autorun, simple move/copy the \SASHIMI\Program\2577 directory to the root of the Storage Card. When the Storage Card is next inserted into a device, SASHIMI will automatically execute in Auto Install Phase.



TIP: Autorun.exe can be run manually from \SASHIMI\Program\2577 to do a quick launch in AUTORUN mode following a clean flash!



NOTE 1: Some other applications may also use a \2577 directory in the Storage Card root for AUTORUN functionality (e.g. TomTom). If this is the case then you must remove or rename the other application's \2577 directory to use SASHIMI's \2577 directory. Only one \2577 directory with its corresponding Autorun.exe file can be active on a device at any time.



UC Initiated - UCInitiated functionality is provided by a set of files in the \SASHIMI\Program\UCINIT directory. Simply copy the SDCONFIG.TXT file from this directory to the \SASHIMI\Program\INI directory. When UC runs it will read this SDCONFIG.TXT file and automatically configure SASHIMI to perform an Autorun following UC's reboot.



NOTE 2: You will need to manually edit the provided SDCONFIG.TXT file if you are using something other than "Storage Card"



TIP 1: A registry key will be set to prevent multiple AUTORUNs of SASHIMI in both of the above scenarios. See the SASHIMI REGISTRY ENTRIES for more information. This behavior can be overridden or manually reset using the Advanced Settings.

i didnt think i needed the UC stuff, but not sure....., sorry for such a long post! thanks in advance!!!

Re: Sashimi
 

Maybe I didn't read your post right but all you have to do to run it is go to \Storage Card\SASHIMI\Program\2577 and run the autorun.exe just like the instructions say. You do it right after a flash. :)

The only thing UC will do (I think) is start SASHIMI automatically after a flash which I would prefer to not happen so you can change anything around that you might need like the screen from turning off when SASHIMI is running since it takes a while for all the CAB's. (yeah yeah I know thats a long run on...)

Re: Sashimi
 

Wow, thanks.... i was making it harder than it is!!!!!

Re: Sashimi
 

Sashimi is a little confusing at first, but it is the best way to quickly setup your stuff after a flash. Of course that's only the beginning. Reg edits, owner info, setting up email, and basically all the stuff that takes time to install and do you can automate.

Re: Sashimi
 

Your poll didn't include Install Express, which I've been playing with and is looking promising.

Re: Sashimi
 

install express is weak sashimi FTW!