Originally Posted by dubroz (Post 2152625)

I just went through an LCD screen and digitizer replacement. There is ONE big surprise .... when peeling the tape off the back of the LCd to remove the flex cable, just pulling on the tape adhesive will rip the flex table!

I followed these directions, the issue I am talking about is step 31 ....

http://m.youtube.com/index?desktop_u...?v=qBw0vTDybuE


The replacement cost is $40, I picked up a used TP2 on craigslist for $50 instead and won't be taking it a part.

Originally Posted by aedon (Post 2152663)

ya I had an issue replacing my screen as well.
all that tar they use to have the screen stay glued to the frame got all over the inside of the phone.

When i pealed the tape off the inside and tried to seperate the glass screen from the lcd, the sheets of the lcd split apart.

I had to get a new lcd

Originally Posted by elesbb (Post 2152675)

i found a paint thinner or mineral spirits soaked towel or like object worked beautifuly to seperate them . just would squeeze out a little bit at a time as i needed it .

Originally Posted by aedon (Post 2152680)

it was just the first one it happend to.
I didnt expect it that time

any time after that it was all gravy lol