Mighty ROM Data & Pic Messaging

[FrozenEntity]

mine is this one: imnuts Verizon ArcSoft MMS 5.2.12.45 20100204.cab, i tried the one you gave me, and it didn't work either =(

[willyjay]

Did you remove the one you had, soft reset, install the new one, soft reset? Also, are you trying to send receive on VZW data, or wifi (you cannot send/receive MMS on wifi)?

Just trying to walk through all of the bases.

[FrozenEntity]

yup, it uninstalled the older one before installing the new one, and im trying to send over vzw data (i guess, since it's not wifi). it keeps saying "message delivery failed."

I tried some tips for this thread too:http://forum.ppcgeeks.com/showthread.php?t=93778

none of it seems to be working

and i soft reset after each install

[willyjay]

Did you make some reg edit changes from the thread listed, or only install the arcsoft cab?

I'm on VZW, and all I do is (basic flash dance, but now task29) install MightyROM (or custom rom of choice), make sure I can send/receive calls (*228 is usually needed to program the phone), install imnut's arcsoft cab (soft reset). Verify that send/receive MMS works.

Not sure how many updates, cabs or personalization you do, but if I had issues, I would hard reset, flash stock, run task29, re-install MightyROM (maybe even redownload jic) and then set up MMS again.

Not really sure why it doesn't work for you.

[FrozenEntity]

i just installed the .cab, no regedits. god this is infuriating!

[willyjay]

Don't get too frustrated....MMS is working for a lot of us VZW folks on MightyROM, as well as other custom rom's.

If it is not too much trouble to re-flash, here is exactly what I do (when flashing) and MMS works with no issues (and roms run flawless)...
Hard reset (clear storage) > flash stock vzw 6.5 (program phone, make sure phone sends/receives > run task29 ( http://forum.ppcgeeks.com/showthread.php?t=116571 ) post #9 .exe from ziggy > soon as task29 is done put into boot loader mode (vol down + end key + reset button) > start flashing MightyROM (soon as it gets past 1% I take out the battery) > right after 100% when you hear usb is disconnected, unplug from computer > wait a few seconds, put the battery back in and hold vol down + send + end to hard reset > provision verison > program phone with *228 and make sure phone sends/receives calls > install imnut's cab > soft reset > verify it works.

I know it's probably waaaay over kill, but I don't have any issues with this method.

EDIT: If it's never worked on MightyROM for you, or if you're having several issues, you may also consider re-downloading the rom.

Edit #2: After flashing stock and custom rom, I program the phone with *228 to make sure the phone works (added above)

[FrozenEntity]

yes! it works!. i shortcutted and didn't hard reset, just used task29, flashed mightyrom, installed imnuts cab and it worked fine. now to reinstall everything lol. Thanks so much!