Ruim Conversion For Ppc6800

[ravjeet]

Procedure to convert ppc6800 to ruim .
1)remove back cover (4 screws) remove the thin sheet metal plate stuck on the pcb.
2) will see six points on the pcb .
3) solder sim tray on these points see direction of ruim card photo att . Remember we require the sim tray as per pin config att
4)solder jumpers as per photo att
5)cut the sheet metal sheet as to accommodate the sim tray.
6)as we have put the sim tray the original battery will not fit find 2400mah extended battery back cover to use with standard battery
7)upgrade radio to 1.47.01 .might have to unlock the pda to upgrade radio . Procedure can be found on net as titan unlocker.
in qpst change config to ruim if avaible can be done with cdma workshop free version also.
Phone is ready for ruim service use.
can be used with bad esn pda with blank ruim witten with esn and other info .

[linuxmugen]

ravjeet,

Do you have the picture for the jumper?

[pflatlyne]

Thats pretty sweet? Can a similar mod be done to a palm?