05-15-2009, 05:37 AM
|
||||
|
||||
WisBar Advance 3 - trouble making an OEM
Has anyone done this successfully? I've been trying to get it right for a few hours now with no luck ...
It cooks, burns, and runs OK but when I open the Theme Manager control panel applet I get no icons ... Apparently whatever I'm missing is affecting WA3's ability to internally load a theme as well, because I have included all the registry keys necessary in my OEM so that WA3 uses a custom theme on my storage card ... But it still loads the default theme ... I've compared registry dumps from a clean flash with my OEM cooked in, to dumps from right after I install with a .CAB, and they are almost identical. I've gone through all the files in the original .CAB to make sure that they had all been accounted for and they seem fine.. I was messing around a bit with SKTracker to look for any other changes made by Setup.DLL that I might be missing, but no luck there... I don't think SKTracker will show files that have been added to the file-system anyway, so it's not much help ... I'm stumped ... If anyone else has gotten WA3 into an OEM successfully please share your secrets ..
__________________
---- volpe Deus ---- Device: HTC RhodiumW (Sprint Branded) ROM: Under Construction -- Radio: Sprint 2.32.00WF -- PRL: 60660 -- OS: WM6.5 b23554 -- GUI: Sense 2.5.2012 --
Last edited by volDeus; 05-15-2009 at 05:40 AM. |
|
05-15-2009, 06:43 AM
|
||||
|
||||
|
Re: WisBar Advance 3 - trouble making an OEM
Solved ... WA3 was looking in a strange place for it's install path when it loaded the Theme Manager applet ... A reg key I usually comment out of my .RGU so my OEMs don't show up in the installed applications list ..
In any event, I un-commented the key and it's working fine now ... I made OEMs of Spb MS3, WA3, TouchResponse, S2U2, Sprite Backup, and SKTools today!!!  Sorry I'm proud of myself 
|
 |
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
All times are GMT -4. The time now is 06:05 AM.
