View Single Post
  #29 (permalink)  
Old 01-09-2010, 05:52 PM
whitey10tc's Avatar
whitey10tc
Almost a VIP
Offline
Threadstarter
Location: Utah
 
Join Date: Jan 2009
Posts: 938
Reputation: 1545
whitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on repwhitey10tc is halfway to VIP status based on rep
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Additional QPST setting

Additional QPST setting
For those that might have problems with setting like the banner or issues with the original carrier setting reverting try the following.
CDMA Tab
change or correct the following
NAM name = cricket

Display Tab
Banner= cricket or anything you want it to read

M.IP Tab
Highlight profile0 and edit the following
profile enabled
NAI MDN@mycricket.com
HA/AAA shared secret password both retain last value
check mark Rev tunnel preferred
home address 0.0.0.0
Primary HA address 68.28.15.12
secondary address 68.28.31.12
MN-HA SPI = 12C
MN-AAA SPI = 2
DMU public key = 0
now click ok back to the main M.IP TAB
Mobile IP Behavior = simple IP only
Initial regestration retry interval = 200 mS
check mark Re-register only if traffic since last RRQ

PPP config Tab
RM button on the right hand side in the you should have blank values in the following tethered NAI, user id, passowrd.
UM button you should have these values on the right hand side. retries 5, timeout 3000, tethered NAI should be blacked out with x's, user id is your mdn@mycricket.com, password is blank.
AN button is the same setting from the UM button

Then you can close out by writing to phone and wait 5 minutes.
This post has been thanked 4 times.