Quote:
Originally Posted by alexmk3
When you say flash to Shipped rom...you mean put back to the original rom? and no i can't get passed that first intro screen...i still can do a hard reset from here? thanks, alex.
|
Ok, yes, you should always flash back to the shipped (if not available then try stock) ROM before you flash to a new custom ROM. You should be able to search and find the stock or shipped ROM for your carrier. Once you have it, flash to it, then hard reset. (You dont have to let it set up the shipped ROM just hard reset once the flash is complete and the phone has restarted.) Once the reset is complete, you can again skip the set up process for the shipped ROM and go directly into Bootloader. From there flash your new custom ROM, hard reset if you like just to be safe, and then go through the set up process. You should have no more issues.
Now to get into bootloader from where you're at (freezing on loading screen) Follow these steps:
1.) pull the battery out and replace it to power off the device.
2.) with power off, press and hold the volume down button and the top power button at the same time. *
Keep holding them down until the tri color screen comes up on the display
3.) That is Bootloader mode. So now you just need to connect it via usb and it should automatically enter an active sync connection, but you wont have all the WM active sync center programs pop up like usual. *
Your pc may detect it as new hardware and intall some drivers the first time you do this. That's normal just let it install them.
That's it. From there you flash using RUU just like you do normally.
To hard reset you follow the same instruction's as above but in step 2 press and hold the center (Enter) button along with the volume down and power buttons.
Finally: All this info is already posted in the forums. Try searching for answers and you'll usually find them.
Hit the THANKS button if I helped you out
